Product Manual

1. To store the inLINE® Back Stretch Bench, simply keep it in a clean dry place.

2. Adjust the CERVICAL TRACTION EXTENDING TUBE(39), HEIGHT ADJUSTMENT BEAM(10), and

MAIN FRAME(22) to the shortest position. The inLINE® Back Stretch Bench is approximately 63.9

inches long x 18.7 inches wide x 11.1 inches tall. These dimensions will vary. Please measure your

inLINE® Back Stretch Bench if exact dimensions are needed.

3. To move the inLINE® Back Stretch Bench, lift by the CERVICAL TRACTION EXTENDING

TUBE(39) on one end and the HEIGHT ADJUSTMENT BEAM(10) at the other end. Use caution as

the SWING ARMS(41) may move and cause a pinching hazard.

The safety and integrity designed into the inLINE® Back Stretch Bench can only be maintained when

the inLINE® Back Stretch Bench is regularly examined for damage and wear. Special attention should

be given to the following:

1. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.

Tighten loose nuts and bolts.

2. Verify that the CAUTION LABEL(60) is in place and easy to read. Call Stamina Products immediately

at 1-800-375-7520 for a replacement CAUTION LABEL(60) if it is missing or damaged.

3. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

4. Worn or damaged components must be replaced immediately or the inLINE® Back Stretch Bench

removed from service until repair is made.

5. Only Stamina Products supplied components should be used to maintain/repair the inLINE® Back

Stretch Bench.

6. Keep your inLINE® Back Stretch Bench clean by wiping it o󰀨 with an absorbent cloth after use.

STORAGE

MAINTENANCE

STRETCH SYSTEM

The inLINE® Back Stretch Bench stretches the back with

its one way rack and pinion engineering. Lie on the inLINE®

Back Stretch Bench with the ARMPIT PADS(46) under your

armpits, and the FOAM PADS(2) holding your ankles. Pull the

LEVER(38) back and forth as many times as needed until you

feel a gentle stretch. Stop pulling at the desired position and stay

at the stretched position for a few minutes. Push the LEVER(38)

rmly toward your feet to release the stretch.

Push the Lever toward

your feet to release.

Pull the Lever back and forth

as many times as needed to

reach the proper stretch.

OPERATIONAL INSTRUCTIONS

NOTE: Prior to releasing the stretch please remove your

arms from the ARMPIT PAD SUPPORTS(42). Once the

ARMPIT PAD SUPPORTS(42) are no longer under your

arms push the LEVER(38) firmly toward your feet to

release the stretch.