User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and operating elements
- 7 Operating
- 7.1 Starting the device
- 7.2 Main menu
- 7.3 Menu overview
- 7.4 Functions in 2-channel DMX mode
- 7.5 Functions in 3-channel DMX mode
- 7.6 Functions in 5-channel DMX mode
- 7.7 Functions in 7-channel DMX mode
- 7.8 Functions in 18-channel DMX mode
- 7.9 Functions in 27-channel DMX mode
- 7.10 Functions in 54-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
Symptom Remedy
The unit does not work, no light,
the display is dark
Check the mains connection and the main fuse.
Apparently no function despite
proper power supply
Check if the unit is in DMX mode or in ‘slave’ mode. If so,
check the device into a dierent mode.
No response to the DMX con‐
troller
1. If the unit is in DMX mode and the display ashes, no
DMX signal is received. Check that the DMX controller is
switched on. Check the DMX connectors and cables for
proper connection.
2. If the unit is in DMX mode and a DMX controller is
connected and turned on, a dot on the fourth digit of
the display will ash. If it doesn't, no valid DMX signal is
received. Check that the DMX controller is switched on.
Check the DMX connectors and cables for proper con‐
nection.
3. If the display dot is ashing but there is still no
response, check the address settings and the DMX
polarity.
4. Try using another DMX controller.
5. Check to see if the DMX cables run near or alongside
to high voltage cables that may cause damage or inter‐
ference to DMX interface circuits.
Troubleshooting
Show Bar TriLED 18x3W RGB, Show Bar TriLED 18x3W RGB WH
41
LED Floodlight