User manual

This setting is only relevant when the device is controlled via DMX.
Press [Mode] repeatedly until the display shows ‘dxxx’ . Press [Setup]. Now use [UP] and [DOWN]
to select one of the following DMX operating modes:
n ‘2-ch’ (two channels)
n ‘3-ch’
(three channels)
n ‘5-ch’ (ve channels)
n ‘7-ch’
(seven channels)
n ‘18ch’ (18 channels)
n ‘27ch’
(27 channels)
n ‘54ch’ (54 channels)
Wait about 30 seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [Mode].
This setting is only relevant if the device is serving as Slave in a Master / Slave conguration
and is not controlled via DMX.
Press [Mode] until the display shows ‘SLAv’ .
Wait about 30 seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [Mode].
DMX mode
Operating mode ‘Slave’
Operating
24
Show Bar TriLED 18x3W RGB, Show Bar TriLED 18x3W RGB WH
LED Floodlight