User manual

Automatic operation can only be activated when the unit is operating in stand alone mode or
as master in a master / slave combination. This setting is only relevant if the device is not con‐
trolled via DMX.
Press [Mode] repeatedly until the display shows ‘Auto’ . Press [Setup] until the display shows
‘nxxx’ . Now you can select an automatic option. Use [Up] and [Down] to select a value between
‘n001’ and ‘n100’ .
To adjust the speed of the selected auto show, press [Setup] repeatedly until the display shows
‘SPxx’ . Use [Up] and [Down] to select a value between ‘SP01’ (slow) and ‘SPFL’ (fast).
To adjust the ash frequency, press [Setup] repeatedly until the display shows ‘FSxx’ . Use [Up]
and [Down] to select a value between ‘FS00’ (slow) and ‘FSFL’ (fast).
Wait about 30 seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [Mode].
Operating mode ‘Automatic’
Operating
22
Show Bar TriLED 18x3W RGB, Show Bar TriLED 18x3W RGB WH
LED Floodlight