User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and operating elements
- 7 Operating
- 7.1 Starting the device
- 7.2 Main menu
- 7.3 Menu overview
- 7.4 Functions in 2-channel DMX mode
- 7.5 Functions in 3-channel DMX mode
- 7.6 Functions in 5-channel DMX mode
- 7.7 Functions in 7-channel DMX mode
- 7.8 Functions in 18-channel DMX mode
- 7.9 Functions in 27-channel DMX mode
- 7.10 Functions in 54-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
A preprogrammed automatic show can only be activated when the unit is operating in stand-
alone mode or as master in a master / slave combination. This setting is only relevant if the
device is not controlled via DMX.
Press [Mode] repeatedly until the display shows ‘Prxx’ . Now you can select one of the preprog‐
rammed automatic shows. Use [Up] and [Down] to select a value between ‘Pr01’ and ‘Pr25’ .
To adjust the speed of the selected auto show, press [Setup] repeatedly until the display indi‐
cates ‘SPxx’ . Use [Up] and [Down] to select a value between ‘SP01’ (slow) and ‘SPFL’ (fast).
To adjust the ash frequency, press [Setup] repeatedly until the display shows ‘FSxx’ . Use [Up]
and [Down] to select a value between ‘FS00’ (slow) and ‘FSFL’ (fast).
Wait about 30 seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [Mode].
Operating mode ‘Preprog‐
rammed automatic show’
Operating
Show Bar TriLED 18x3W RGB, Show Bar TriLED 18x3W RGB WH
21
LED Floodlight