User manual

The ‘Static Color’ operating mode can only be activated when the device is operating alone or
is the master in a master/slave conguration. This setting takes eect only when the device is
not operated under DMX control. The brightness and ashing frequency can be set manually
on the device.
Press [Mode] until the display shows ‘C-ON’ .
Press [Setup]. The display shows ‘C.255’ . Use the [Up] and [Down] buttons to set the brightness
in a range from ‘C.000’ to ‘C.255’ (o to maximum brightness).
Press [Setup] again. The display shows ‘F5.00’ . Use the [Up] and [Down] buttons to set the ash
frequency in a range from ‘F5.00’ to ‘F5.99’ (permanent light to maximum ash frequency).
Proceed as follows to reset the device to factory defaults (e.g. if the device or the display stops
responding to inputs).
1. To disconnect the device from the power supply, unplug the power cord.
2. Press and hold [Mode] and [Setup] simultaneously.
3. Reconnect the device to the mains. The display briey sows ‘resr’ and then the current
operating mode.
‘Static Color’ operating mode
Resetting to factory defaults
Operation
24
LED Flash LF12
Stroboscope