User manual

This setting takes eect only when the device is operated under DMX control.
Press [Mode] until the display shows ‘d.xxx’ .
Use the [Up] and [Down] buttons to select a DMX address in a range from ‘d.001’ to ‘d.512’ .
Press [Setup]. Use the [Up] and [Down] buttons to select one of the following DMX modes:
‘1.1ch.’ , one channel Brightness control via the connected controller, range: 1
… 255
‘1.2ch.’ , one channel Flash frequency contro via the connected controller,
range: 1 … 255
‘3-ch.’ , three channels Channel CH1: Brightness control via the connected con‐
troller, range: 1 … 255
Channel CH2: Flash frequency contro via the connected
controller, range: 1 … 255
Channel CH3: Sensitivity control of the built-in micro‐
phone for the sound control via the connected con‐
troller, range: 1 … 255
DMX mode
Operation
LED Flash LF12
23
Stroboscope