User manual

7 Operation
To start up the device, connect it to the mains. The device is immediately ready for operation.
To select an operating mode, press [Mode]. If you do not press any key for about ten seconds,
the display will be blanked. To turn the display on again, press any key. The previously selected
menu is displayed again.
The set values are retained during a power interruption.
The ‘Sound Active’ operating mode can only be activated when the device is operating alone
or is the master in a master/slave conguration. This setting takes eect only when the device
is not operated under DMX control. In this operating mode, the device responds to acoustic
pulses which are recorded by the integrated microphone.
Press [Mode] until the display shows ‘SoUn’ .
Press [Setup]. Use the [Up] und [Down] buttons to set the sensitivity of the built-in microphone
for the sound control in a range from ‘SU.00’ to ‘SU.31’ .
This setting takes eect only when the device is the slave in a master/slave conguration and is
not operated under DMX control. In this operating mode, the device responds to the control
signals of the master device.
Press [Mode] until the display shows ‘SLAv’ .
Starting up the device
‘Sound Active’ operating mode
‘Master/slave’ operating mode
Operation
22
LED Flash LF12
Stroboscope