User manual

This setting is only relevant if the unit is controlled via DMX.

Press [Mode] repeatedly until the display shows ‘dxxx’ .

Now you can set the number of the rst DMX channel to be used by the device (DMX address).

Use [Up] and [Down] to select a value between 1 and 512 (the display shows ‘d001’ … ‘d512’ ).

Make sure that this number matches the conguration of your DMX controller. The following

table shows the highest possible DMX address for the dierent DMX modes.

Mode Highest possible DMX address

2-channel 511

3-channel 510

5-channel 508

24-channel 489

Wait for about 30 seconds until the display turns dark. Then the settings have been applied.

Press [Mode] to return to the parent menu without any changes.

DMX address

Operating

LED Bar 240/8 RGB