User manual

This setting is only relevant if the device is controlled via DMX.
Press [Mode] repeatedly until the display shows ‘dxxx’ . Press [Setup]. Now use [Up] and [Down]
to select one of the following DMX operating modes:
n ‘2-ch’ (two channels)
n ‘3-ch’
(three channels)
n ‘5-ch’ (ve channels)
n ‘12-ch’
(twelve channels)
Wait about ten seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [Mode].
This setting is only relevant if the device is serving as Slave in a Master / Slave conguration
and is not controlled via DMX.
Press [Mode] repeatedly until the display shows ‘SLAv’ .
Wait about ten seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [Mode].
DMX mode
Operating mode ‘Slave’
Operating
LED Bar 120/4 RGB DMX
29
LED Floodlight