User manual

This setting is only relevant if the device is controlled via DMX.
Press [Mode] repeatedly until the display shows ‘dxxx’ .
Now you can set the number of the rst DMX channel to be used by the device (DMX address).
Use [Up] and [Down] to select a value between 1 and 512 (display shows ‘d001’ … ‘d512’ ).
Make sure that this number matches the conguration of your DMX controller. The following
table shows the respective highest possible DMX address for the various DMX modes.
Mode Highest possible DMX address
2-channel 511
3-channel 510
5-channel 508
12-channel 501
Wait about ten seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [Mode].
DMX address
Operating
28
LED Bar 120/4 RGB DMX
LED Floodlight