User manual

Display Description
‘9.-on’ Red, green and blue
‘ 0.OFF’ LEDs o
To adjust the ash frequency, press [Setup]. Now use [Up] and [Down] to select a value
between ‘FS.00’ (slow) and ‘FS.99’ (fast).
Settings for programmes 02 to 20:
To adjust the speed of the selected auto show, press [Setup] repeatedly until the display indi‐
cates ‘SPxx’ . Now use [Up] and [Down] to select a value between ‘SP.01’ (slow) and ‘SP.99’
(fast) or ‘SP.FL’ (Flash eect).
To adjust the ash frequency, press [Setup]. Now use [Up] and [Down] to select a value
between ‘FS.00’ (slow) and ‘FS.99’ (fast).
Wait about ten seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [Mode].
Automatic operation can only be activated when the unit is operating in stand alone mode or
as master in a master / slave combination. This setting is only relevant if the device is not con‐
trolled via DMX.
Press [Mode] repeatedly until the display shows ‘Auto’ .
Wait about ten seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [Mode].
Operating mode ‘Automatic’
Operating
LED Bar 120/4 RGB DMX
27
LED Floodlight