Manual

www.thomann.deINVADER 2420
www.thomann.de
INVADER 2420
39
6. Move FADERS 1-24 and use Jog wheel #3, #4 to change the centre position of
PAN, TILT where you desired. (The codes of the channel feature of ARRT CODE are
“P”, “PF”, “T”, “TF” in the xtures bank) for the convenience to check other channels,
there would be some output of the channels, but the channel output will not be
stored in the centre.
7. Press MANUAL/REC button, at this moment, all LEDs on CUE, OVERRIDE,
CENTRE, FIXTURE GROUP, PRESET, CHASE, BANK, BLACKOUT blink at the
same time.
8. Press CENTRE button.
9. Press the number button 1-20 to select the location to store the Centre, all LEDs
blink for 3 times to indicate that you have successfully edited a Centre position.
10. Press PROGRAM button for 3 seconds to exit Program mode, the LED goes out
indicating this operation.
NOTE: If you press different buttons in step 3 and 9, the centre position you set in step 3 will cover the one in step 9.
2.19 Programming an override
1. Enter Program mode.
2. Press FIXTURE button.
3. Press the number button 1-20 to select the concerned xtures to be programmed.