Manual

www.thomann.deINVADER 2420
www.thomann.de
INVADER 2420
37
8. Press the number button 1-20 to select the xture group number you selected in
step 2, all LEDs blink for 3 times
9. Press PROGRAM button for 3 seconds to exit Program mode, the LED goes out
indicating this operation.
NOTE: If you press different buttons in step 3 and 7, the xture group you selected in step 4 will cover the one
in step 7.
2.17 Programming a centre
1. Enter Program mode.
2. Press FIXTURE button.
3. Press the number button 1-20 to select the concerned xtures to be programmed.
4. Move FADERS1-24 and use Jog wheel #3, #4 to change the centre position of PAN,
TILT where you desired. (The codes of the channel feature of ARRT CODE are “P”,
“PF”, “T”, “TF” in the xtures bank) for the convenience to check other channels,
there would be some output of the channels, but the channel output will not be
stored in the centre.
5. Press MANUAL/REC button, at this moment, all LEDs on CUE, OVERRIDE,
CENTRE, FIXTURE GROUP, PRESET, CHASE, BANK, BLACKOUT blink at the
same time.