Manual
www.thomann.de
INVADER 2420
22
www.thomann.deINVADER 2420
7. Repeat steps 2-6 to program other scenes.
8. Press PROGRAM button for 3 seconds to exit Program mode, the LED goes out
indicating this selection.
2.2 Program a scene with movement
1. Enter Program mode.
2. Press the button 1-20 to select Fixture, you can select several xtures at a time by
tapping of these buttons.
3. Move Faders 1-24 or use the CENTRE, PRESET, SCENE have saved to change the
output of each channel, press MOVEMENT button.
4. Press the button 1-10 to select one MOVEMENT in ten, the selected FIXTURE will
run the MOVEMENT.
5. If it is necessary to adjust MOVEMENT parameter, use Jog wheel #2 to select the
adjusting MOVEMENT parameter options (position & range & fade time or wait time
& loop), use Jog wheel #3, #4 to adjust parameter values.
6. Repeat Steps 2 – 5to select MOVEMENT for other FIXTURE.
7. Press MANUAL/REC to store into memory, all the LEDs on CUE, OVERRIDE,
CENTRE, FIXTURE GROUP, PRESET, CHASE, BANK, BLACKOUT blink to
indicate this operation.
8. Press BANK use Jog wheel #1 to select the BANK number to store the scene.
9. Press the number button 1-20 to select the Scene number going to be saved, all
LEDs and the Segment Display will blink for three times briey indicating this
operation, then the LCD will show the bank and the scene number of the
programmed scene.
10. Repeat steps 2-9 to program other SCENEs with MOVEMENT.