Manual

www.thomann.deINVADER 2420

www.thomann.de

INVADER 2420

4. Press ENTER/MAIN MENU Button to store and back to the main menu back to the

main menu without any change. Press ESC/CLEAR Button.

2 Programming mode

Press PROGRAM button for 3 seconds, the LED above this button lights blinking

indicating Program in active.

2.1 Setting a scene

1. Enter Program mode.

2. Press the button 1-20 to select Fixture, you can select several xtures at a time by

tapping of these buttons.

3. Slide Faders 1-24 or use the CENTRE or PRESET or SCENE have saved to change

the output of each channel. You can also use the jog wheel #1 & #2 to control the

PAN, PAN FINE or use the jog wheel #3 #4 to control TILT, TILT FINE.

4. Once the scene is satisfactory, press MANUAL/REC button to program this scene

into memory. At this moment, the LEDs on CUE, OVERRIDE, CENTRE, FIXTURE

GROUP, PRESET, CHASE, BANK, BLACKOUT button blink at the same time.

5. Press BANK use the Jog wheel #1 to select the BANK number to save the scene.

6. Press the number button 1-20 to select the Scene number going to be saved, all

LEDs and the Segment Display will blink three times briey indicating this operation,

then the LCD will show the bank and the scene number of the programmed scene.