User manual: SW V1.0

Table Of Contents
6 Operating
After switching the Invader on, the console automatically performs a self-test, its pro‐
gress will appear on the display. Once this is completed, the device can be used.
6.1 ‘Setting’ menu
1. Enter the programming mode by holding down the [PROGRAM] button for 2
seconds. The LED of the [PROGRAM] button ashes when the programming
mode is activated.
2. Hold down the [ENTER / MAIN MENU] button for 2 seconds to enter the main
menu.
The main menu allows to access the following 17 sub menus:
1. Create a new xture prole
2. Modify a xture prole
3. Delete a xture prole
4. Patch a xture
5. Reverse channel setup
6. Fade mode select
7. Blackout mode select
8. MIDI channel select
9. Chase run by inside/outside time
10. Auto remote address
11. Read U disk
12. Write U disk
13. Modify password
14. Enable password
15. Erase all memory
16. Audio input range adjust
17. Channel value display mode
Select the desired menu item with jog wheel # 1 and press the [ENTER / MAIN MENU]
button to enter the respective submenu for editing.
Calling up the menu
Operating
DMX Invader 2420 MK II
15