User manual

4 Starting up
Unpack and check carefully there is no transportation damage before using the unit. Keep the
equipment packaging. To fully protect the product against vibration, dust and moisture during
transportation or storage use the original packaging or your own packaging material suitable
for transport or storage, respectively.
Create all connections while the device is o. Use the shortest possible high-quality cables for
all connections. Take care when running the cables to prevent tripping hazards.
You can use either a 9-V battery or the 9-V connector for external power supply. Before con‐
necting check for correct polarity.
To insert or change the battery, switch o the device rst and disconnect the power adapter
from the device. Loosen the screws located at the four edges of the base plate. Do not loosen
the three screws in the middle of the base plate. Carefully remove the base plate. Take care not
to damage the cables. Change the battery. Remount the base plate without squeezing the
cables. Insert and tighten the screws.
When a battery is inserted, 9-V external power adapter must not be connected!
Power supply
Changing the battery
Starting up
12
DDC-6
DMX Controller