User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Setup
- 6 Connections and operating elements
- 7 Operating
- 7.1 Starting the device
- 7.2 Device functions
- 7.3 Foot switch
- 7.4 Remote control
- 7.5 Operating on the unit
- 7.6 Menu overview
- 7.7 Functions in 2-channel DMX mode
- 7.8 Functions in 3-channel DMX mode
- 7.9 Functions in 4-channel DMX mode
- 7.10 Functions in 7-channel DMX mode
- 7.11 Functions in 8-channel DMX mode
- 7.12 Functions in 14-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
Symptom Remedy
The unit does not work, no light Check the mains connection and the fuse.
No response to the DMX con‐
troller
1. If the dot behind the rst character of the display is
ashing in the DMX mode, no DMX signal is received.
Make sure that the DMX controller is turned on. Check
the DMX ports and cables for proper connection.
2. If the display does not ash and still no response,
check the address settings and the DMX polarity.
3. Try using another DMX controller.
4. Check to see if the DMX cables run near or alongside
to high voltage cables that may cause damage or inter‐
ference to DMX interface circuits.
If the procedures recommended above do not succeed, please contact our Service Center. You
can nd the contact information at www.thomann.de.
Troubleshooting
LED lighting set
58