User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Setup
- 6 Connections and operating elements
- 7 Operating
- 7.1 Starting the device
- 7.2 Device functions
- 7.3 Foot switch
- 7.4 Remote control
- 7.5 Operating on the unit
- 7.6 Menu overview
- 7.7 Functions in 2-channel DMX mode
- 7.8 Functions in 3-channel DMX mode
- 7.9 Functions in 4-channel DMX mode
- 7.10 Functions in 7-channel DMX mode
- 7.11 Functions in 8-channel DMX mode
- 7.12 Functions in 14-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
A sound controlled automatic show can only be activated when the unit is operating in stand
alone mode or as master in a master / slave combination. This setting is only relevant if the
device is not controlled via DMX.
Press [Mode] repeatedly until the display shows ‘SOud’ .
Press [Setup] and use [Up] and [Down] to adjust the sensitivity for the built-in microphone in a
range from ‘SO.00’ (low sensitivity) to ‘SO.31’ (high sensitivity).
Press [Setup] again and activate with [Up] and [Down] one of the programmed shows ‘SU.01’ to
‘SU.31’ .
Sound control
Operating
LED lighting set
42