User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Setup
- 6 Connections and operating elements
- 7 Operating
- 7.1 Starting the device
- 7.2 Device functions
- 7.3 Foot switch
- 7.4 Remote control
- 7.5 Operating on the unit
- 7.6 Menu overview
- 7.7 Functions in 2-channel DMX mode
- 7.8 Functions in 3-channel DMX mode
- 7.9 Functions in 4-channel DMX mode
- 7.10 Functions in 7-channel DMX mode
- 7.11 Functions in 8-channel DMX mode
- 7.12 Functions in 14-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
A preprogrammed automatic show can only be activated when the unit is operating in stand-
alone mode or as master in a master / slave combination. This setting is only relevant if the
device is not controlled via DMX.
Press [Mode] repeatedly until the display shows ‘Pr.xx’ . Now you can select one of the preprog‐
rammed automatic shows. Use [Up] and [Down] to select a value between ‘Pr.01’ and ‘Pr.14’ .
Settings for programme 01:
For ‘Pr.01’ , you can choose from 14 colours, white or blackout. Press [Setup]. With [Up] and
[Down] you can now select one of the colours.
To adjust the strobe frequency, press [Setup] again. The display shows ‘FS00’ . Use [Up] and
[Down] to select a value between ‘FS00’ (slow) and ‘FS99’ (fast).
Settings for programmes 02 to 14:
To adjust the programme speed, press again [Setup]. The display shows ‘SPxx’ . Use [Up] and
[Down] to select a value between ‘SP01’ (slow) and ‘SPFL’ (fast).
To adjust the strobe frequency, press [Setup] again. The display shows ‘FS00’ . Use [Up] and
[Down] to select a value between ‘FS00’ (slow) and ‘FS99’ (fast).
Operating mode ‘Preprog‐
rammed automatic show’
Operating
LED lighting set
38