User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Setup
- 6 Connections and operating elements
- 7 Operating
- 7.1 Starting the device
- 7.2 Device functions
- 7.3 Foot switch
- 7.4 Remote control
- 7.5 Operating on the unit
- 7.6 Menu overview
- 7.7 Functions in 2-channel DMX mode
- 7.8 Functions in 3-channel DMX mode
- 7.9 Functions in 4-channel DMX mode
- 7.10 Functions in 7-channel DMX mode
- 7.11 Functions in 8-channel DMX mode
- 7.12 Functions in 14-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
Press the lock of the battery holder to the centre of the housing and pull out the battery holder
like a drawer. Insert the battery. The battery is correct if the positive pole points to the housing
base of the remote control. Slide the battery holder back into the remote until it clicks into
place.
When shipping, the battery is already installed in the remote and protected against discharge
by a transparent plastic foil. Remove the plastic foil prior to rst use.
Please note that this device must not be connected to a dimmer.
Inserting the battery into the
remote control
Installation
CLB4 RGB Compact LED Bar 4
21