Operation Manual

075-0041_A 8
1-2 Cable Mode
1-3 DTV Signal
Digital cable is supported depending on transmission system. When QAM is set, 64/256 QAM is automatically detected and
set. This works only when Tuning Band is set to cable. Please check with your cable provider whether the transmission
system is 8VSB, 64QAM or 256QAM. Encrypted signals from paid channels cannot be converted into video/audio. When
transmission is 8VSB, set cable mode at VSB. When transmission is 64/256 QAM, set cable mode at QAM.
1) Use CHANNEL  keys to select DTV Signal.
2) Use Volume  key to enter.
Signal Window meter will show signal strength.
(weak/normal/strong)
1) Use CHANNEL  to select Cable Mode.
2) Use Volume  to enter / change setting.
(VSB – QAM)
Input Signal Level Requirements
Common sources of television signal are cable, satellite or over-the-air antenna systems. Many of these choices will
provide signal in analog, digital or both even both formats. In order to provide high-quality images, the signal level supplied
to each screen should be in the range of +5dBmV to +15 dBmV when read on analog channels. A signal level outside of
this range will provide less than optimum results
To EXIT
1) Push VOLUME  to exit Sub MENU / MENU
Enter MENU (0002) and CHANNEL  to “Channel”
Use Volume  to enter.
To EXIT
1) Push VOLUME  to exit Sub MENU / MENU
Enter MENU (0002) and CHANNEL  to “Channel”
Use Volume  to enter.