Operation Manual

075-0041_A 5
1) SMV-1 LCD Personal Viewing Screen
2) Power Supply
3) AC Power Supply Cord
4) Manual
1
DC Power Input. 2.5mm DC jack.
5
Audio/Video Input. RCA jacks
2
AUX TV Controller Cable port. RJ45 jack.
6
AUX Audio Output. 3.5mm stereo jack
3
AUX RGB Input. HD-15 jack
7
RF Signal Input. TYPE "F Connector
4
AUX Audio Input. 3.5mm stereo jack
Mounting the Screen and Making the Connections
DC Power In
1
2
3
4
5
6
7
RF “F”
A/V IN (RCA STYLE)
Audio In
3.5mm
RGB
RJ45
CONNECTION IDENTIFICATION
Audio Out
3.5mm
Use the four screws (included) to fasten the screen to
the mount. Using screws other than those supplied,
may result in damage to the screen. It is highly
recommended to not use a power tool when
tightening these screws, as this may result in
damage to the screen. Use a #2 Phillips screwdriver,
taking care not to over-tighten!
SCREEN MOUNTING SCREWS
Fasten the F-connector of the coaxial cable on to the
fitting on the rear of the screen. It is important that
care be taken with this connector, as
over-tightening will result in serious damage to
the screen. This connector should be started using
only fingers and then tightened to 20 inch-pounds of
torque, slightly more than finger-tight.
Carefully unscrew Strain Relief cable clamp from
enclosure rear. Do not use power tools. Run the DC
cable through the cable clamp and reattach.This will
help prevent the power cable from becoming
accidentally unplugged during use. Insert the DC
power plug to the TV power jack.
IN THE BOX…