User Manual

30
Intended Purpose
Manoskop
®
721 and 730 have been
designed for controlled tightening of
screw joints in a workshop environment.
In order to loosen a nut or bolt during the
normal tightening process, the
Manoskop
®
can also be used in the
opposite direction. Manoskop
®
721 and
730 may only be used for these purposes.
To do so, the correct attachments must be
used with the torque wrench.
The „intended purpose“ includes full
adherence to the information contained in
this instruction booklet, in particular the
safety instructions and technical tolerance
limits. The buyer is required to ensure that
all users comply with these instructions.
Any use beyond the use described here is
in breach of the intended purpose.
The buyer and user are responsible for
any damage or injury resulting from non-
adherence to these instructions.
• Manoskop
®
721 and 730 have not
been designed for tightening of screw
joints under series production
conditions. This might lead to
inaccurate readings as a result of
inadvertent operation of the sliding
scale.
• The Manoskop
®
may not be used as
a hammer. This will lead to injury and
damage.
ã
Important safety
points