User Manual

46
Proceed as follows:
1. With the Manoskop
®
730/2 and
730/4, remove the plastic cover first.
With other models, remove the two plugs
using a sharp object. Retain the plugs for
later use.
2. To adjust the lower end of the range,
insert the Allen key in the hole nearer
to the handle. To adjust the lower end
of the range, insert the Allen key in
the other hole.
3. Turn the Allen key with great care and
very slowly. Turning in a clockwise
direction increases the cut-out torque
level, turning in the other direction
decreases it. The screws will lock in
any position.
4. Once you have made an adjustment
using one screw, check the effect by
testing the cut-out value on the torque
tester.
5. Repeat the adjustment of one or both
screws and the testing process until
the deviation has been compensated.