Installation Instructions

INSTALLATION

Unroll the RoofKit White Reinforced Membrane over the

substrate so that the sheet is in the desired position and is

wrinkle free. If more than one roll of membrane is required,

subsequent rolls must over lap the prior roll a minimum of

three inches (3") for seaming. Start at the low side of roof if

seaming rolls. Care should be taken to ensure the membrane

overhangs the perimeter of the roof at least three inches (3").

Allow the RoofKit White Reinforced Membrane to relax

for approximately 25 minutes depending upon weather

conditions.

Fold the membrane onto itself so that one-half (1/2) of the

underside of the membrane is exposed. Take care to avoid

wrinkles.

White Membrane Water Based

Bonding Adhesive: (Plastic Container)

(May be applied in one of two methods)

One-Sided Application Method for Field of Roof: Open and

thoroughly stir the Water Based Bonding Adhesive. Using a

3/4 “large nap paint roller, apply the Water Based Bonding

Adhesive to the substrate at a rate of 100 square feet per gal-

lon. Then carefully fluff air under the top half of the membrane

and roll the membrane into the wet adhesive starting from the

middle of the membrane first, followed by the ends. DO NOT

let the ends of the membrane roll ahead of the middle. Lightly

broom the membrane to remove any air pockets or wrinkles

and to ensure transfer of adhesive to the bottom side of the

membrane. Caution: limit foot traffic on the membrane while

FIGURE 1 - Fastening Pattern