Installation Instructions

SEAMING MEMBRANE

The top membrane should overlap the bottom sheet by 3". Mark

a line ½ inch out from the edge of the top roof membrane. Fold

back the top 3" overlap and clean both surfaces of the area to be

seamed with the RoofKit Seam Primer using scrubbie pad and

allow to dry completely. Fold the top

membrane sheet back to expose the

seam area. (HINT: A small piece of

seam tape that is tacky on both sides

is useful to tack the membrane back.)

Ensure the entire area is primed past

the seam edge to the marked line.

Unroll the Seam Tape along the length

of the seam, paper side up, aligning

the Seam Tape paper with the marked line. Then with the

release paper still in place, roll the Seam Tape with a steel or

hard roller. This will set the Seam Tape into place and keep

air from being trapped under the tape. Fold the top membrane

back onto the Seam Tape release paper .

Reaching under the top ply of membrane, pull the release

paper away from the Seam

Tape at a 45

angle to the

seam. While removing

the paper, draw your hand

across the seam, from the

back to the leading edge.

This will prevent wrinkles

and fishmouths from

forming in the seam. After

the paper is removed, roll the entire length of the seam with a

steel or hard roller – first, across the seam, and then the length

of the seam.

IMPORTANT! If the White Seam Tape does not visibly extend

beyond the leading seam edge, the edge should be cleaned with

Seam Primer and sealed with White Membrane Caulk.

NOTE: When splicing the ends of Seam Tape together,

overlap each piece a minimum of one inch (1") and firmly roll

with a steel or hard roller.

seamed with the RoofKit Seam Primer using scrubbie pad and