Operating instructions

• Never insert objects into the grille of the fan. Do not cover the appliance
during operation.
• Always disconnect the power cord from the socket before removing the
protection grille.
• Only connect the cable to alternating current. Observe the voltage infor-
mation given on the appliance.
• Do not use damaged extension cords.
• Do not run the power cord over sharp edges and make sure that it does
not get trapped.
• Do not pull the plug from the socket with wet hands or by holding on to
the power cord.
• Do not use the appliance in immediate vicinity of a bath tub, a shower or a
swimming pool (observe a minimum distance of 3 m). Place the appliance
such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the supply cord is damaged, it must be replaced by the manufacturer, or
its service agent, or a qualified person in order to avoid a hazard.
• Prior to any maintenance, cleaning and after each use, switch off the ap-
pliance and unplug the mains cable from the socket.
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician.
Assembly (see page 2 and 3)
Attention: The protection grille must be properly closed prior to switch-
ing on the appliance so as to avoid any damage or hazards. Ensure that
all screws and securing nuts are firmly tightened. Only connect the power
cable to the socket once assembly has been completed.
A. Remove fixing screw (3) on underside of connector (1). Insert connector
(1) into foot (2) and secure with fixing screw for foot and connector (3).
B. Undo fixing screw (5) on connector (1). Locate motor housing (4) on con-
nector (1) and secure with fixing screw for motor housing and foot (5).
C. Remove securing nut for grille (6) from motor housing (4) and locate pro-
tection grille rear (7) on motor housing (4). When locating, ensure that
the handle (8) on protection grille rear (7) is on the top. Now screw se-
curing nut for grille (6) back on to motor housing (4) so as to fix protection
grille rear (7) in position.
D. Attach fan blades (9) to motor housing (4) and secure in position with
fixing screw for fan blades and motor housing (10) (loosely attached to
fan blade). Tighten screw to secure fan blades (9).
E. Locate protection grille front (11) on protection grille rear (7). In doing
so, take care to ensure that positioning clip (12) on protection grille front