Operating Guide
STACK-ON PRODUCTS CO.
P.O. BOX 489, WAUCONDA, IL 60084
9123-1204
2
12
If the door of the safe starts to rub on the door
frame, open the door per the instructions above.
By the door hinges you will nd a threaded stem.
Use an Allen Wrench to tighten the threaded stem.
is will help realign the door and give you trouble
free access to the contents of your safe.
You can turn o the "Beep" sound of the keypad by
entering the code 633.
To turn the "Beep" sound on, enter the code 66.
For best results this safe should be installed in an
isolated, dry and secure area.
For greater security the safe should be fastened to
solid surfaces. Ideally the safe would be installed
to both a wall and permanent shelf.
Secure the safe to the wall and permanent shelf
using the holes and hardware provided. (see gure
1)
Mark the holes to be used. Drill the appropriate
diameter and depth of pilot holes depending on the
type of hardware being used and the type of
mounting surface.
Secure the safe with the fasteners.
NOTE: e safe needs to be upright and right side
up or the locking mechanism will not function
properly.
FIGURE 1
NOTE: Do not mix old and new baeries. Do not
mix alkaline, standard or rechargeable baeries.
is safe uses 4 - AA baeries. Under normal use,
baeries will last about 1 year.
When the baery is low, a red light will come on
warning you that the baery is low.
To test the baeries, enter your security code. If the
baeries are low the red light located in the middle of
the top of the keypad will start to ash.
To replace the baeries, open the baery
compartment on the back of the door by pushing the
tab in the direction of the arrow and install all new
baeries.
YOU MUST REPROGM YOUR SECURITY
CODE AFTER YOU REPLACE THE BAERIES.
SEE STEPS 1-3 UNDER "ENTERING YOUR
SECURITY CODE".
BATTERY REPLACEMENT
SECURING THE SAFE
SELECTING A LOCATION
TURNING THE KEYPAD SOUND
OFF/ON
MAINTENANCE FOR KEY AND
ELECTRONIC SAFES
IMPORTANT
Keep keys and your combination number in a secure
place, away from children. Keep this record of your serial
number and combination in a secure place separate from
your safe. To order a replacement key set, follow the
instructions on the aached form.