User Manual

40536-1506
3
18
NOTE: Do not mix old and new baeries. Do not
mix alkaline, standard or rechargeable baeries.
is safe uses 4 - AA baeries. Under normal use,
baeries will last about 1 year.
NOTE: If the baeries are low, the yellow light will
ash when you start to enter your code.
To replace the baeries, open the baery
compartment on the back of the door by pushing the
tab in the direction of the arrow and install all new
baeries.
BATTERY REPLACEMENT
TURNING THE KEYPAD SOUND
OFF/ON
You can turn o the "Beep" sound of the keypad
by pressing the ... key.
To turn the "Beep" sound on, press the ....
key again.
SECURING THE SAFE
DRAWER MOUNTING
Select an appropriate sized drawer for your safe.
Place the safe in the drawer and try opening and
closing the safe and drawer. Do not aempt to
close the drawer with the safe open.
Place the safe in the desired drawer and mark the
mounting holes with a pencil. Remove the safe and
drill the pilot holes for the screws. Replace the safe
in the drawer and insert the screws through the
mounting holes and drawer boom. For maximum
security, use 2 mounting screws. Secure the screw
by tightening the Nylock nut on the screws.
(Figure 1)
Figure 1
SELECTING A LOCATION
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
is safe must be mounted into a drawer
(PDS-1500) or into a drawer or the wall
(PDS-1505). For optimal safety and security, the
safe should be installed in an isolated, dry and
secure area.
NOTE: is safe must be mounted into a drawer
(PDS-1500) or into a drawer or the wall
(PDS-1505). Failure to do so will compromise
the safety and security of the safe.
Your safe comes with the "Beep" sound turned on.