Instructions / Assembly

LOCKING THE SAFE
To lock the safe, close the door and rotate the
handle counter clockwise until it stops. If the
handle is not turned until it stops, the locking
mechanism will not lock.
NOTE ON LOCKING THE SAFE: Because
the locking mechanism is deactivated for
approximately 3 to 6 seconds aer the
combination is entered, wait a minimum of 6
seconds from the time the combination is entered
to lock the safe.
SECURING THE SAFE
SELECTING A LOCATION
1
Secure the safe with the fasteners and replace the
carpeting.
Use these holes to fasten the safe to the oor. Drill
the appropriate diameter and depth of pilot holes
into the oor depending on the type of hardware
being used and the type of oor surface. (Figure 2)
To secure your safe to the oor it will rst be
necessary to drill pilot holes through the re
insulation in the oor of the safe. First place the safe
in the desired location. Li the boom carpeting up
to nd the two hole locations marked on the oor
insulation. Drill holes through the insulation using
the same diameter drill as the diameter of the
mounting hardware you are using.
IMPORTANT: e fasteners you use must
completely ll the hole you drilled into the
insulation. (Figure 1) You must use the fasteners
aer you drill the holes. Failure to do so will void the
re rating.
2
e safe should be at against the wall and oor.
Remove the baseboard if necessary.
e safe must be mounted to the oor. For
optimal safety and security, the safe should be
installed adjacent to a side wall with minimal
space on either side of the safe, in an isolated,
dry and secure area.
CHILDREN SHOULD NOT PLAY
WITH OR AROUND THE SAFE AT
ANY TIME.
NOTE: e safe must be secured to the oor.
Use the hardware provided or consult your
hardware retailer for fastening hardware for your
particular mounting surface.
NOTE: is safe must be mounted to the oor.
Failure to do so will compromise the safety and
security of the safe.
4
14
TURNING THE KEYPAD SOUND OFF/ON
You can turn o the "Beep" sound of the keypad by
entering the code 6 3 3.
To turn the "Beep" sound on, enter the code 6 6.
40-0000100_2004