User manual

System extension through additional sensors
For extending the alarm system stabo multifon home guard, additional remote controls, door/window
contacts and motion detectors are available in specialist shops.
The radio sensors included in the scope of delivery of the basic set are already coupled ex works
to the system. However, all additional sensors (and spare sensors as well) must be registered
on the base station prior do installation. Several zones in different blocks are available to do so
(refer to tables on p. 39/40).
The registration is done using the Reset/S3 key at the back side of the base station.
Registering an additional remote control
A maximum number of 10 remote controls can be coupled in total to the system. For registering
the remote controls, Zone 00 is reserved.
Press 1x the Reset/S3 key at the back side of the base station. The ring lights up blue and a
signal tone sounds.
Briefly press 2x an arbitrary key of the remote control.
The ring twice flashes blue for confirming the registration.
Registering an additional door/window contact
For registering a door/window contact (e.g. in Zone 08) press 9x the Reset/ S3 key at the back
side of the base station. The ring lights up blue and a signal tone sounds.
Activate the door/window contact (open the closed contact 1x and close it again). The ring twice
flashes blue for confirming the registration.
Afterwards you can name the sensor as requested using the option Change Zone Attribute and
activate the triggering delay in case of need.
Registering an additional motion detector
For registering a motion detector (e.g. in Zone 11) press 12x the Reset/ S3 key at the back side
of the base station. The ring lights up blue and a signal tone sounds.
Trigger the radio motion detector. The ring twice flashes blue for confirming the registration.
Afterwards you can name the sensor as requested using the
option Change Zone Attribute and activate the triggering delay
in case of need.
Removing a sensor
For removing a sensor from a zone (e.g. 06), use the menu
option Change Zone Attribute.
Tap on Please enter zone number and enter the number of
the corresponding zone (for instance 06).
Tap on Yes.
Now tap on Done to send your settings to the base station.
38