User manual

ManualsBrandsSTABO ManualsAlarm Systems (fire, gas, water)Smoke detector battery-powered

Prior to using the smoke alarm device for the first time,

carefully read through all mounting and operating instructions.

The photoelectric cell installed in the stabo smoke alarm device checks the ambient air for smoke particles

which occur in the event of a fire. Both an optical (rapidly flashing LED) and an acoustic (piezosiren

85 dB (A)/3m) alarm is triggered if a certain smoke particle concentration is reached.

Fire and a smoldering fire in particular often lead to a persistent smoke emission with toxic flue gas before

outbreak of flames. For this reason, an early detection of home fires with the help of smoke alarm devices

can save lives and avoid high property damage.

However, the alarm signaling device cannot detect neither heat, nor gas nor fire. By using a smoke alarm

device, a fire can neither be avoided nor extinguished.

Mounting and operating instructions

Photoelectric

smoke alarm device

Article no. 51113

0832-CPR-F0916

EN 14604:2005/AC:2008

Rauchwarnmelder/smoke detector

Leistungserkl./DoP: LE-51113.2

Summary of content (4 pages)

PAGE 1
3 0832-CPR-F0916 EN 14604:2005/AC:2008 Rauchwarnmelder/smoke detector Leistungserkl./DoP: LE-51113.2 Photoelectric smoke alarm device Article no. 51113 Mounting and operating instructions Prior to using the smoke alarm device for the first time, carefully read through all mounting and operating instructions. The photoelectric cell installed in the stabo smoke alarm device checks the ambient air for smoke particles which occur in the event of a fire.
PAGE 2
Important safety notes and warnings l Assure the best possible coverage of your entire living space with smoke alarm devices: One smoke alarm device is only able to early detect smoke particles in a certain area! l Install the smoke alarm device in a fairly accessible place (cleaning/tests)! l The housing of the smoke alarm device may neither be coated, nor painted, nor may something be stuck on it! In any case, the openings of the housing must always remain free and open! l Keep your smoke alarm devices cl
PAGE 3
Installation and mounting For assuring the minimum coverage of your home, one smoke alarm device should be installed respectively in the hallway/on the stairs and in every bedroom, for providing additional protection in the living room and/or rooms equipped with electrical devices (e.g. TV or computer room). Install the smoke alarm device always on the ceiling, if possible in the middle.
PAGE 4
Exchanging / replacing the alarm system The power supply of the stabo smoke alarm device is provided through a 9 V block battery having a lifetime of approx. 1 year under normal operating conditions. If the battery capacity becomes weak, a clearly audible beep sounds every 30 - 40 seconds (warning duration: 30 days at least). In this case, immediately exchange the used battery! Disposal instruction Electronic devices and used up batteries are not to be thrown into the domestic waste.