User manual

Functions/settings of the settings menu
Function Menu item Description/possible settings
Receive codes S01 RXC None
(CTCSS/DCS) CTC: 50 CTCSS frequencies from 67,0 to 254,1 Hz
DCSN: 107 codes from 017N to 754N
DCSI: 107 inverse codes from 017i to 754i
Transmit codes S02 TXC None
(CTCSS/DCS) CTC, DCSN, DCSI like under receive codes
AF expander S03 EXP ON/OFF, a 2:1 expander is switched on or off during reception.
Compressor S04 COM ON/OFF, a 1:2 compressor is switched on or off
during transmission.
Noise blanker/ANL S05 NB ON/OFF, Noise blanker and automatic noise limiter
are switched on/off during reception.
RF attenuator S06 ATT ON/OFF, a 20 dB attenuator is switched on/off
during reception.
Hi-Cut S07 HIC ON/OFF, attenuates high tones thus reducing
the high-frequency noise
Busy lockout S08 BSY OFF: Transmission is always possible.
SQ: While squelch is opened, transmission is not possible
(pressing the key intermediately is not possible).
C/D: During CTCSS or DCS operation, transmission is
possible as long as the code squelch is opened.
Roger beep S09 RB OFF/1 to 8 (choose among eight different melodies).
DTMF transmission S10 BOT OFF/M01 to M16 (choose among one of 16 DTMF
when transmission memory location: The corresponding DTMF tone sequence
starts is transmitted at the beginning of each broadcasting).
DTMF transmission S11 EOT OFF/M01 to M16 (choose among one of 16 DTMF
when transmission memory location: The corresponding DTMF tone sequence
ends is transmitted at the end of each transmission).
DTMF call S12 CAL OFF/M01 to M16 (choose among one of 16 DTMF
memory location: The corresponding DTMF tone sequence
is transmitted at the beginning of the next transmission
when pressing the Call key on the microphone.
Transmitting power AM S13 PAM High/low (transmitting power in AM 1 W or 4 W)
Transmitting power FM S14 PFM High/low (transmitting power in FM 1 W or 4 W)
Input/modification of the settings in the settings menu
Note: After 10 seconds without user interaction, the radio set automatically exits the menu, all
modifications will be stored!
Press SET key (channel switch) for 2 sec.:
S01 flashes, the settings menu is activated.
Select the requested menu item using the channel switch
(refer to menu table: S01  S14).
After having selected the requested parameters,
press SET key again: The corresponding parameter flashes.
By turning the channel switch, the settings can be modified.
(For S01 and S02, additional frequencies or codes can be selected:
To do so, press the SET key again.)
Confirm by pressing the SET key: The selected parameter flashes again.
Store and exit the settings menu by pressing the PTT button.
27