User manual

Menu functions

Functions/settings of the memory menu

Function Menu item Description/possible settings

Transmit time limit M01 TOT OFF, 15 to 600 sec.

Display lighting M02 LED ON/AUTO (lighting is switched off after 10 sec. without

user interaction)/OFF

Display color M03 COR Seven colors are available for the display lighting.

When the LOOP function is activated, the color changes

every second.

DTMF memory M04 DTMF Sixteen memory locations for DTMF tone sequences

locations (M01 to M16)

Channel scanning M05 SCN SQ: The scan function depends on the squelch.

When the squelch function is deactivated and the

delay time (M06 SCT) has elapsed, the radio set

starts scanning again.

TI: Scanning is interrupted by opening the squelch

function and is activated again when the delay time

(M06 SCT) has elapsed.

Delay time scan M06 SCT Adjustment of the delay time for the scan functions SQ

and TI (5 to 60 sec.)

Roger beep M07 BEP ON/OFF, roger beep on/off.

Parameter transfer M08 PD ON/OFF: When the function is activated, a just modified

to other channels parameter is not only applied to the adjusted channel,

but to all other channels as well.

When PD is deactivated, the settings previously stored

for the respective channels are again applied to the parameter.

DTMF tone length M09 DSU Specifies the duration of a DTMF tone (30 to 500 millisec.).

For each DTMF system, 100 ms should be enough for evaluation.

Input/modification of the settings in the memory menu

Note: After 10 seconds without user interaction, the radio set automatically exits the menu, all

modifications will be stored!

Press FUNC key: FUNC is displayed.

Press SET key (channel switch): M01 is displayed.

The memory menu is activated.

Select the requested menu item using the channel switch

(refer to menu table: M01  M09).

After having selected the requested menu item,

press SET key again: The corresponding parameter flashes.

By turning the channel switch, the settings can be modified.

(With M04 DTMF, a DTMF code can be entered after having selected the

memory location (M01 to M16) and after having pressed the SET key once again.)

Confirm by pressing the SET key: The selected parameter flashes again.

Store and exit the memory menu by pressing the PTT button.