User manual

24
Operation/functions
At first, a description of the basic functions of your radio set is provided, these functions are
operated using the front keyboard of the device.
All further functions/individual settings which are controlled via the two menus (memory and
settings menu) are presented in tabular form.
Finally, we provide you with explanations on the individual functions or supplemental information
on how to operate the radio set in a gateway.
Basic functions
Switching on
After having established all connections (incl. microphone and antenna!) switch your radio set
on using the VOL/OFF control (if the display is not lit, check the power supply and fuse). Adjust
the SQ control such that the background noise from the loudspeaker just disappears.
Frequency tables/channel configurations
The xm 4006e is equipped with six switchable frequency tables: Select the corresponding channel
configuration depending on the country in which your radio set shall be operated (factory setting:
E). In Germany, this radio set is free of charge and can be operated with each channel configuration
without any registration.
Important notes: Prior to using the radio set abroad, find out more about the current national
provisions: Be sure to observe the relevant provisions as well as any possible obligation to register!
E 40
channels FM (4 W), 40 channels AM (4 W)
D 80
channels FM (4 W), 40 channels AM (4 W) free of licence and charges in Germany
EU 40
channels FM (4 W), 40 channels AM (1 W) free of licence and charges in D, B, F, NL, P
individual licence required in CH
EC 40 channels FM (4 W) CEPT free use in all CEPT-countries
in some countries individual licence is required
PL 40
channels FM (4 W), 40 channels AM (4 W) only allowed in Poland
carrier offset -5 KHz
U 40 channels FM (4 W) UK only allowed in UK
40
channels FM (4 W) CEPT
This radio is not allowed to be used in A!
Changing the frequency table/channel configuration
1. Switch the radio set off.
2. Hold the FUNC key pressed and switch on the radio set again: When the country code is
displayed, release the FUNC key again.
3. Use the channel switch to select the requested channel configuration.
4. Switch the radio set off and on again: The new channel configuration is now activated.
Channel selection
Use the channel switch to adjust the channel you wish to use for receiving/transmitting.
Choosing the type of modulation (AM/FM)
Using the adjustments 40/40 and 80/40 you can either operate your radio set in FM or in AM
modulation. Frequency-modulated signals (FM) are less sensitive to interferences resulting from
the ignition system etc. than amplitude-modulated signals (AM). The decision, which type of
modulation is your preferred one, depends on your radio contact partners and on your and/or the
legal requirements.
If your loudspeaker emits an unintelligible, distorted signal, you should try receiving the signal
using a different type of modulation. You can change the type of modulation by pressing the A/F key.