User manual

23
Charging the battery packs in the charger
Switch off the radio sets!
Plug the power supply unit into a
socket (230 V) and connect it to the
charger.
Place the radio sets into the two
charging shafts.
Both control lamps on the charger
emit red light, the battery packs are
now being charged.
If the control lamps light up green
the battery packs are fully charged.
Remove the devices.
Safety instructions for the charger
Only use the charger in closed rooms. Protect it from humidity, dust,
heat and strong vibrations. The charger should be used only at tempe-
ratures between 5° and 40° C (charging outside the recommended
temperature range may result in battery packs which are not fully
charged).
The double tabletop charger must only be used for the charging of the
Li-Ion battery packs that are included in the scope of delivery! The
charger must only be operated with the delivered power supply unit.
Do not abuse it as DC voltage source for other applications.
Do not disassemble neither the power supply unit nor the charger.
Prevent small metal parts from penetrating into the charger.
Make sure that the radio sets are switched off during charging.
Do not charge the radio set if it has become wet! Only place the radio
set into the charger, if it is completely dry.
Disconnect the device from the mains if you do not use it.
Never short-out the contacts of the battery packs. Never throw the
battery packs into the fire.