Product Manual
Table Of Contents
- 1. Intended use
- 2. Safety information
- 3. Components of the unit
- 4. Display elements
- 5. Commissioning
- 5.1 Inserting batteries/battery replacement
- 5.2 Switching the unit on
- 6. Functions
- 6.1 Visual guidance
- 6.2 Acoustic guidance
- 6.3 Automatic display inversion
- 6.4 Setting the MODE unit of measurement
- 6.5 Locking the measurement with HOLD
- 6.6 Freely selectable zero position REF
- 6.7 Lighting
- 6.8 Button lock
- 6.9 Automatic switch-off time: Auto OFF
- 7. Checking the measuring tool
- 7.1 Accuracy check
- 7.2 Calibration
- 7.3 Adjusting the sensor
- 7.4 Error messages
- 8. Technische Daten
TECH 500 DP
9
en
6.4 Setting the MODE unit of measurement
6.5 Locking the measurement with HOLD
The unit of measurement is set by pressing the "MODE"
button several times.
° Fine: Display in 0.01° steps
° Rough: Display in 0.1° steps
%: Display in 0.1 % steps
mm/m: Display in 1 mm/m steps
in/ft decimal: Display in 0.01 in/ft steps
in/ft fraction: Display in 1/8 in/ft steps
The set unit of measurement is retained after the unit is
switched off.
The current measurement can be locked by pressing the
"HOLD" button. The visual guidance indicator flashes.
The measurement is displayed continuously.
The locked measurement is deleted by pressing the "HOLD"
button again or switching the unit off.
0,1˚
MODE
0,01°