Product Manual
Table Of Contents
- 1. Intended use
- 2. Safety information
- 3. Components of the unit
- 4. Display elements
- 5. Commissioning
- 5.1 Inserting batteries/battery replacement
- 5.2 Switching the unit on
- 6. Functions
- 6.1 Visual guidance
- 6.2 Acoustic guidance
- 6.3 Automatic display inversion
- 6.4 Setting the MODE unit of measurement
- 6.5 Locking the measurement with HOLD
- 6.6 Freely selectable zero position REF
- 6.7 Lighting
- 6.8 Button lock
- 6.9 Automatic switch-off time: Auto OFF
- 7. Checking the measuring tool
- 7.1 Accuracy check
- 7.2 Calibration
- 7.3 Adjusting the sensor
- 7.4 Error messages
- 8. Technische Daten
TECH 500 DP
6
en
5.2 Switching the unit on
Unscrew battery compartment lid, insert new batteries into
battery compartment according to symbol.
Suitable rechargeable batteries can also be used.
LCD indicator:
Battery low – insert new batteries
Dispose of used batteries at suitable collection
points – not with household waste. Do not
leave in unit!
If you do not intend to use the unit for an
extended period, remove the batteries.
5.1 Inserting batteries/battery replacement
5. Commissioning
After switching on with the "ON/OFF" button, an automatic
test is carried out. All the display's segments are shown.
After the end of the test, the version number S x.xx of the
software is briefly displayed and the automatic switch-off
time (Auto OFF) is shown.
An acoustic signal indicates that the unit is ready for
operation.
The display shows the angle measured in the set unit of
measurement.
Alkaline