Product Manual
Table Of Contents
- 1. Intended use
- 2. Safety information
- 3. Components of the unit
- 4. Display elements
- 5. Commissioning
- 5.1 Inserting batteries/battery replacement
- 5.2 Switching the unit on
- 6. Functions
- 6.1 Visual guidance
- 6.2 Acoustic guidance
- 6.3 Automatic display inversion
- 6.4 Setting the MODE unit of measurement
- 6.5 Locking the measurement with HOLD
- 6.6 Freely selectable zero position REF
- 6.7 Lighting
- 6.8 Button lock
- 6.9 Automatic switch-off time: Auto OFF
- 7. Checking the measuring tool
- 7.1 Accuracy check
- 7.2 Calibration
- 7.3 Adjusting the sensor
- 7.4 Error messages
- 8. Technische Daten
TECH 500 DP
14
en
7.3 Adjusting the sensor
The sensor must be adjusted if the temperature or Cal.
symbols are shown in the display.
A:
All 4 planes are adjusted during the sensor adjustment.
B:
The sensor can only be adjusted if the two black bars
appear on the display (in the range of 0° and 90°).
C:
CAL and the planes still to be adjusted flash alternately
while the sensor is being adjusted for the respective plane.
D:
Planes that have not been adjusted flash in the display.
Successfully adjusted planes are permanently indicated
in the display.
A
B
1
2
3
C
D