Product Manual
Table Of Contents
- 1. Intended use
- 2. Components of the unit
- 3. Display elements
- 4. Commissioning
- 4.1 Power supply - Charging the Li-ion rechargeable battery
- 4.2 M12 socket pin assignment
- 4.3 Connection cable
- 4.4 Switching the unit on
- 5. Functions
- 5.1 Visual guidance
- 5.2 Acoustic guidance
- 5.3 Automatic display inversion
- 5.4 Setting the "MODE" unit of measurement
- 5.5 Locking the measurement with "HOLD"
- 5.6 Freely selectable zero position "REF"
- 6. "FUNC" button settings
- 7. Checking the measuring tool
- 7.1 Accuracy check
- 7.2 Calibration -– Adjustment
- 7.3 Calibration
- 7.4 Adjusting the sensor
- 7.5 Error messages
- 8. Data transfer
- 8.1 Querying the measurement
- 8.2 Changing the bus address
- 8.3 Error codes
- 8.4 Auto mode
- 8.5 Print mode
- 9. STABILA Analytics evaluation software (optional)
- 10. Technical data
TECH 1000 DP
4
en
Display
Mains adapter connection, M12 socket
Rare-earth magnet
T-groove profile for securing with M4 groove stones, e.g.
Bosch Rexroth
®
or square nut in accordance with DIN 557
V-shape for aligning on round surfaces
Buttons:
Units of measurement: °, %, mm/m, in/ft
Function selection
Lighting, acoustic guidance, keylock, unit settings, Auto
OFF, baud rate, battery status
Calibration, sensor adjustment
Confirm entry
On/Off
Reference – freely selectable zero position
HOLD – lock measurements
Print mode – manual transmission of measurements
(1)
(2)
(3)
(4)
(5)
2. Components of the unit
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
3.5 mm
12