Product Manual
Table Of Contents
- 1. Intended use
- 2. Components of the unit
- 3. Display elements
- 4. Commissioning
- 4.1 Power supply - Charging the Li-ion rechargeable battery
- 4.2 M12 socket pin assignment
- 4.3 Connection cable
- 4.4 Switching the unit on
- 5. Functions
- 5.1 Visual guidance
- 5.2 Acoustic guidance
- 5.3 Automatic display inversion
- 5.4 Setting the "MODE" unit of measurement
- 5.5 Locking the measurement with "HOLD"
- 5.6 Freely selectable zero position "REF"
- 6. "FUNC" button settings
- 7. Checking the measuring tool
- 7.1 Accuracy check
- 7.2 Calibration -– Adjustment
- 7.3 Calibration
- 7.4 Adjusting the sensor
- 7.5 Error messages
- 8. Data transfer
- 8.1 Querying the measurement
- 8.2 Changing the bus address
- 8.3 Error codes
- 8.4 Auto mode
- 8.5 Print mode
- 9. STABILA Analytics evaluation software (optional)
- 10. Technical data
TECH 1000 DP
3
en
1. Intended use
Congratulations on the purchase of your STABILA measuring
tool. The STABILA TECH 1000 DP is a digital measuring tool
for measuring inclinations.
If you still have questions aer reading through the
operating instructions, you can obtain advice by
telephone:
+49 63 46 3 09 0
Equipment and functions:
• Tough, independent 360° digital protractor for quick and
accurate measurements
• Integrated rare-earth magnet for attachment
• Integrated V-groove for aligning on round surfaces
• Integrated T-groove for attachment
• Integrated Li-ion rechargeable battery
• Digital protractor with fast, direct transfer of
measurement data via a RS485 interface
• Digital protractor for measuring / monitoring via
MODBUS-compatible data trac
• Carrying case
• Mains adapter
• RS 485 data cable <− > open
• RS 485 data cable <− > USB (optional)
• STABILA Analytics evaluation soware (optional)