Product Manual
Table Of Contents
- 1. Intended use
- 2. Components of the unit
- 3. Display elements
- 4. Commissioning
- 4.1 Power supply - Charging the Li-ion rechargeable battery
- 4.2 M12 socket pin assignment
- 4.3 Connection cable
- 4.4 Switching the unit on
- 5. Functions
- 5.1 Visual guidance
- 5.2 Acoustic guidance
- 5.3 Automatic display inversion
- 5.4 Setting the "MODE" unit of measurement
- 5.5 Locking the measurement with "HOLD"
- 5.6 Freely selectable zero position "REF"
- 6. "FUNC" button settings
- 7. Checking the measuring tool
- 7.1 Accuracy check
- 7.2 Calibration -– Adjustment
- 7.3 Calibration
- 7.4 Adjusting the sensor
- 7.5 Error messages
- 8. Data transfer
- 8.1 Querying the measurement
- 8.2 Changing the bus address
- 8.3 Error codes
- 8.4 Auto mode
- 8.5 Print mode
- 9. STABILA Analytics evaluation software (optional)
- 10. Technical data
TECH 1000 DP
2
en
Contents
Section Page
• 1. Intended use 3
• 2. Components of the unit 4
• 3. Display elements 5
• 4. Commissioning 6
• 4.1 Power supply - Charging the Li-ion rechargeable battery 6
• 4.2 M12 socket pin assignment 6
• 4.3 Connection cable 7
• 4.4 Switching the unit on 7
• 5. Functions 8
• 5.1 Visual guidance 8
• 5.2 Acoustic guidance 9
• 5.3 Automatic display inversion 9
• 5.4 Setting the "MODE" unit of measurement 10
• 5.5 Locking the measurement with "HOLD" 10
• 5.6 Freely selectable zero position "REF" 11
• 6. "FUNC" button settings 12
• 7. Checking the measuring tool
13
• 7.1 Accuracy check 13
• 7.2 Calibration -– Adjustment 13
• 7.3 Calibration 14
• 7.4 Adjusting the sensor 15
• 7.5 Error messages 18
• 8.
Data transfer 19
• 8.1 Querying the measurement 20
• 8.2 Changing the bus address 21
• 8.3 Error codes 21
• 8.4 Auto mode 22
• 8.5 Print mode 22
• 9. STABILA Analytics evaluation software (optional) 23
• 10. Technical data 23