Product Manual
Table Of Contents
- 1. Intended use
- 2. Components of the unit
- 3. Display elements
- 4. Commissioning
- 4.1 Power supply - Charging the Li-ion rechargeable battery
- 4.2 M12 socket pin assignment
- 4.3 Connection cable
- 4.4 Switching the unit on
- 5. Functions
- 5.1 Visual guidance
- 5.2 Acoustic guidance
- 5.3 Automatic display inversion
- 5.4 Setting the "MODE" unit of measurement
- 5.5 Locking the measurement with "HOLD"
- 5.6 Freely selectable zero position "REF"
- 6. "FUNC" button settings
- 7. Checking the measuring tool
- 7.1 Accuracy check
- 7.2 Calibration -– Adjustment
- 7.3 Calibration
- 7.4 Adjusting the sensor
- 7.5 Error messages
- 8. Data transfer
- 8.1 Querying the measurement
- 8.2 Changing the bus address
- 8.3 Error codes
- 8.4 Auto mode
- 8.5 Print mode
- 9. STABILA Analytics evaluation software (optional)
- 10. Technical data
TECH 1000 DP
12
en
The user can switch between the different setting options
by repeatedly pressing the "FUNC" button. While the display
is flashing, the selected function can be confirmed with the
"ENTER" button. If no button is pressed, the "FUNC" menu
closes after a short time.
The "ON/OFF", "FUNC" and "ENTER" buttons are always
active.
With battery operation: switch between 0.2 and 2 hours.
The unit is permanently on when connected to an external
power supply.
The baud rate can be set from 1200 – 19,200 Bd.
The Analytics evaluation software can only be connected
with a baud rate of 9600 Bd.
6. "FUNC" button settings
Ref
Adj.
data
6.1. Lighting
6.2 Acoustic guidance
6.3 Keylock
6.4 STABILA internal
information
6.5 Auto OFF
6.6 Baud rate
6.7 Unit address
6.8 Battery status