Product Manual
Table Of Contents
- 1. Intended use
- 2. Components of the unit
- 3. Display elements
- 4. Commissioning
- 4.1 Power supply - Charging the Li-ion rechargeable battery
- 4.2 M12 socket pin assignment
- 4.3 Connection cable
- 4.4 Switching the unit on
- 5. Functions
- 5.1 Visual guidance
- 5.2 Acoustic guidance
- 5.3 Automatic display inversion
- 5.4 Setting the "MODE" unit of measurement
- 5.5 Locking the measurement with "HOLD"
- 5.6 Freely selectable zero position "REF"
- 6. "FUNC" button settings
- 7. Checking the measuring tool
- 7.1 Accuracy check
- 7.2 Calibration -– Adjustment
- 7.3 Calibration
- 7.4 Adjusting the sensor
- 7.5 Error messages
- 8. Data transfer
- 8.1 Querying the measurement
- 8.2 Changing the bus address
- 8.3 Error codes
- 8.4 Auto mode
- 8.5 Print mode
- 9. STABILA Analytics evaluation software (optional)
- 10. Technical data
TECH 1000 DP
10
en
in/ft
5.5 Locking the measurement with "HOLD"
The current measurement can be locked by pressing the
"HOLD" button. The relevant inclination triangle and the
bars flash. The "Hold" symbol is displayed continuously.
The measurement is displayed continuously.
The locked measurement is deleted by pressing the "HOLD"
button again or switching the unit off.
5.4 Setting the "MODE" unit of measurement
The unit of measurement is set by pressing the "MODE"
button several times.
° Precise Display in 0.01° increments
° Rough Display in 0.1° increments
% Display in 0.1% increments
mm/m Display in 1 mm/m increments
in/ft Display in 0.01 in/ft increments
The set unit of measurement is retained after the unit is
switched off.
100%
0%
0%
°
1000 mm/m
0 mm/m
°
0°
359.99°
0°
359.9°
0 in/ft
12 in/ft
0 in/ft
Hold