Datasheet
Table Of Contents
- 1 Characteristics
- Table 1. Absolute maximum ratings
- Table 2. Electrical characteristics (Tj = 25 C, unless otherwise specified)
- Table 3. Static characteristics
- Table 4. Thermal resistances
- Figure 1. Maximum power dissipation versus on-state rms current (full cycle)
- Figure 2. On-state rms current versus lead (TO-92) or tab (SOT-223, SMBflat- 3L) temperature (full cycle)
- Figure 3. On-state rms current versus ambient temperature (free air convection full cycle)
- Figure 4. Relative variation of thermal impedance versus pulse duration (Zth(j-a))
- Figure 5. Relative variation of holding current and latching current versus junction temperature (typ. values)
- Figure 6. Relative variation of gate trigger current (IGT) and voltage (VGT) versus junction temperature
- Figure 7. Surge peak on-state current versus number of cycles
- Figure 8. Non-repetitive surge peak on-state current and corresponding value of I2t sinusoidal pulse width
- Figure 9. On-state characteristics (maximum values) (ITM = f(VTM)
- Figure 10. Relative variation of critical rate of decrease of main current versus (dV/dt)c
- Figure 11. Relative variation of critical rate of decrease of main current (dI/dt) versus junction temperature
- Figure 12. SOT-223 and SMBflat-3L thermal resistance junction to ambient versus copper surface under case
- Figure 13. Relative variation of static dV/dt immunity versus junction temperature (gate open)
- 2 Ordering information scheme
- 3 Packaging information
- 4 Ordering information
- 5 Revision history
Packaging information Z01
8/12 Doc ID 7474 Rev 10
3 Packaging information
● Epoxy meets UL94, V0
● Lead-free packages
In order to meet environmental requirements, ST offers these devices in different grades of
ECOPACK
®
packages, depending on their level of environmental compliance. ECOPACK
®
specifications, grade definitions and product status are available at: www.st.com
.
ECOPACK
®
is an ST trademark.
Figure 15. SOT-223 footprint dimensions (in millimeters)
Table 6. SOT-223 dimensions
Ref.
Dimensions
Millimeters Inches
Min. Typ. Max. Min. Typ. Max.
A 1.80 0.071
A1 0.02 0.10 0.001 0.004
B 0.60 0.70 0.85 0.024 0.027 0.033
B1 2.90 3.00 3.15 0.114 0.118 0.124
c 0.24 0.26 0.35 0.009 0.010 0.014
D
(1)
1. Do not include mold flash or protrusions. Mold flash or protrusions shall not exceed 0.15mm (0.006inches)
6.30 6.50 6.70 0.248 0.256 0.264
e 2.3 0.090
e1 4.6 0.181
E
(1)
3.30 3.50 3.70 0.130 0.138 0.146
H 6.70 7.00 7.30 0.264 0.276 0.287
V10° max
A
A1
e1
D
B1
H
E
e
12
4
3
B
V
c
3.25
1.32
7.80
5.16
1.32
2.30 0.95