Tus neeg siv phau ntawv

1.2 Hardware and software requirements
The
X-NUCLEO-GNSS2A1 must be plugged onto an STM32 Nucleo development board through the Arduino
UNO R3 connectors, as shown in the figure below.
Figure 2. X-NUCLEO-GNSS2A1 expansion board connected to an STM32 Nucleo development board
The X-NUCLEO-GNSS2A1 can be connected to any STM32 Nucleo development board, even though complete
testing has been performed on the NUCLEO-F401RE board.
To use the
STM32 Nucleo development boards with the X-NUCLEO-GNSS2A1 expansion board, the following
software and hardware specifications are required:
• a PC with Microsoft Windows
®
10 to install the software package (
X-CUBE-GNSS1);
• an
STM32 Nucleo development board (NUCLEO-L053R8 or NUCLEO-F401RE);
• a type A to mini-B USB cable to connect the
STM32 Nucleo to the PC;
• the
X-CUBE-GNSS1 software package;
•
TESEO-SUITE.
The installation of the X-CUBE-GNSS1 and the TESEO-SUITE graphical user interface utility on the user PC
requires:
• 128 MB of RAM;
• 40 MB of hard disk space.
UM3020
Hardware and software requirements
UM3020 - Rev 1
page 3/21