Datasheet
TS391, TS391A
Absolute maximum ratings and operating
conditions
DocID6324 Rev 8
5/14
3 Absolute maximum ratings and operating conditions
Table 1: Absolute maximum ratings (AMR)
Symbol
Parameter
Value
Unit
V
CC
Supply voltage
±18 or 36
V
V
id
Differential input voltage
±36
V
i
Input voltage
-0.3 to 36
V
o
Output voltage
(1)
36
Output short-circuit to ground
(2)
Infinite
T
j
Maximum junction temperature
150
°C
T
stg
Storage temperature range
-65 to 150
R
thja
Thermal resistance junction to ambient
(3)
SOT23-5
250
°C/W
DFN8 2x2
57
ESD
Human body model (HBM)
(4)
1500
V
Machine model (MM)
(5)
100
Charged device model (CDM)
(6)
1000
Notes:
(1)
Output voltage can be set up to 36 V even if the V
CC
is lower.
(2)
Short-circuits from the output to V
CC
+
can cause excessive heating and potential destruction. The maximum
output current is approximately 20 mA independent of the magnitude of V
CC
+
.
(3)
Short-circuits can cause excessive heating. These values are typical.
(4)
Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a 1.5 kΩ
resistor between two pins of the device. This is done for all couples of connected pin combinations while the other
pins are floating.
(5)
Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between two
pins of the device with no external series resistor (internal resistor < 5 Ω). This is done for all couples of connected
pin combinations while the other pins are floating.
(6)
Charged device model: all pins and package are charged together to the specified voltage and then discharged
directly to ground through only one pin. This is done for all pins.
Table 2: Operating conditions
Symbol
Parameter
Value
Unit
V
CC
Supply voltage
2 to 36 or ±1 to ±18
V
V
icm
Input common mode voltage range
(1)
T
amb
= 25 °C
0 to (V
CC
+
) - 1.5
T
min
≤ T
amb
≤ T
max
0 to (V
CC
+
) - 2
T
oper
Operating free-air temperature range
-40 to 125
°C
Notes:
(1)
The input common-mode voltage of either input signal voltage should not be allowed to go negative by more
than 0.3 V. The upper end of the common-mode voltage range is (V
CC
+
) – 1.5 V, but either or both inputs can go
to 30 V without damage.