Datasheet
Table Of Contents
- Figure 1. ESDAxxSC5 functional diagram
- Figure 2. ESDAxxSC6 functional diagram
- 1 Characteristics
- Table 1. Absolute ratings (Tamb = 25 C)
- Table 2. Electrical characteristics - definitions (Tamb = 25 C)
- Table 3. Electrical characteristics - values (Tamb = 25 C)
- Figure 3. Peak power dissipation versus initial junction temperature
- Figure 4. Peak pulse power versus exponential pulse duration (Tj initial = 25 C)
- Figure 5. Clamping voltage versus peak pulse current (Tj initial = 25 ˚C). Rectangular waveform tp = 2.5 µs
- Figure 6. Capacitance versus reverse applied voltage (typical values)
- Figure 7. Relative variation of leakage current versus junction temperature (typical values)
- Figure 8. Peak forward voltage drop versus peak forward current (typical values)
- 2 Application information
- 3 Technical information
- 4 Ordering information
- 5 Package information
- 6 Ordering information
- 7 Revision history
Technical information ESDAxxSCx
6/11
3 Technical information
3.1 ESD protection
The ESDA19SC6 is particularly optimized to perform ESD protection. ESD protection is
achieved by clamping the unwanted overvoltage. The clamping voltage is given by the
following formula :
V
CL
= V
BR
+ R
d
.
I
PP
As shown in Figure 11., the ESD strikes are clamped by the transient voltage suppressor.
Figure 11. ESD clamping behavior (example)
To have a good approximation of the remaining voltages at both VI/O side, we provide the
typical dynamical resistance value Rd. By taking into account the following hypothesis :
R
g
> R
d
and R
load
> R
d
we have:
The results of the calculation done for V
g
= 8 kV, R
g
= 330 Ω (IEC61000-4-2 standard),
V
BR
= 19 V (typ.) and R
d
= 0.80 Ω (typ.) give:
V
ouput
= 38.4 V
This confirms the very low remaining voltage across the device to be protected. It is also
important to note that in this approximation the parasitic inductance effect was not taken into
account. This could be a few tenths of volts during a few nanoseconds at the output side.
ESD Surge
Voutput
Rload
Rg
Rd
V
BR
Vg
Device
to be
protected
ESDA19SC6
V
output
V
BR
R
d
+
V
g
R
g
------ -
×=